Wheel Nut Torque for Ford Mustang S550 (2015–2023)
2015–2023 · Australian Market
The wheel nut torque for the Ford Mustang S550 (2015–2023) is 204 Nm (≈ 150 ft·lbs), tightened in a star pattern with a calibrated torque wrench.
Wheel Nut Torque
≈ 150 ft·lbs
Socket Size
21mm
Bolt Pattern
5x114.3
Thread Size
M14 x 1.5
Source
Ford Mustang S550 owner manual — 150 lb-ft (204 Nm), M14 studs. Corrected from 150 Nm (lb-ft/Nm confusion)
Always verify with your vehicle's owner manual. Use a calibrated torque wrench. TorqSpec accepts no liability for damage or injury.
Frequently Asked Questions
What is the wheel nut torque for the Ford Mustang S550 (2015–2023)?
The wheel nut torque for the Ford Mustang S550 is 204 Nm (≈ 150 ft·lbs), shown in the torque specification card at the top of this page. Use a calibrated torque wrench set to this value, following the star-pattern tightening sequence shown in the diagram further down this page.
What socket size do I need for Ford Mustang wheel nuts?
You'll need a 21mm socket, shown in the Socket Size card in the hardware specifications section of this page. The matching M14 x 1.5 thread and 5x114.3 stud pattern are displayed alongside it in the same grid.
What is the bolt pattern for the Ford Mustang S550?
The Ford Mustang S550 uses a 5x114.3 bolt pattern (5 studs), shown in the Bolt Pattern card in the hardware specifications section of this page. The thread size is M14 x 1.5.
What is the correct wheel nut tightening sequence for the Ford Mustang?
Tighten the wheel nuts in a star (cross) pattern — never sequentially around the wheel — so clamping force spreads evenly across the 5 studs. The exact tightening sequence for the 5-stud Ford Mustang wheel is shown in the diagram on this page. Torque in stages (snug, then half torque, then full torque) and re-check after 50–100 km.
5-Stud Wheel
Correct Tightening Pattern
Sequence: 1 → 3 → 5 → 2 → 4