Wheel Nut Torque for Suzuki Alto HA25 (2009–2014)
2009–2014 · Australian Market
The wheel nut torque for the Suzuki Alto HA25 (2009–2014) is 85 Nm (≈ 61 ft·lbs), tightened in a star pattern with a calibrated torque wrench.
Wheel Nut Torque
≈ 61 ft·lbs
Socket Size
17mm
Bolt Pattern
4x100
Thread Size
M12 x 1.25
Source
NJY professional OE torque chart (p.37) — Alto 2009-10: 85 Nm (61 ft-lbs); same generation through AU run
Always verify with your vehicle's owner manual. Use a calibrated torque wrench. TorqSpec accepts no liability for damage or injury.
Frequently Asked Questions
What is the wheel nut torque for the Suzuki Alto HA25 (2009–2014)?
The wheel nut torque for the Suzuki Alto HA25 is 85 Nm (≈ 61 ft·lbs), shown in the torque specification card at the top of this page. Use a calibrated torque wrench set to this value, following the star-pattern tightening sequence shown in the diagram further down this page.
What socket size do I need for Suzuki Alto wheel nuts?
You'll need a 17mm socket, shown in the Socket Size card in the hardware specifications section of this page. The matching M12 x 1.25 thread and 4x100 stud pattern are displayed alongside it in the same grid.
What is the bolt pattern for the Suzuki Alto HA25?
The Suzuki Alto HA25 uses a 4x100 bolt pattern (4 studs), shown in the Bolt Pattern card in the hardware specifications section of this page. The thread size is M12 x 1.25.
What is the correct wheel nut tightening sequence for the Suzuki Alto?
Tighten the wheel nuts in a star (cross) pattern — never sequentially around the wheel — so clamping force spreads evenly across the 4 studs. The exact tightening sequence for the 4-stud Suzuki Alto wheel is shown in the diagram on this page. Torque in stages (snug, then half torque, then full torque) and re-check after 50–100 km.
4-Stud Wheel
Correct Tightening Pattern
Sequence: 1 → 3 → 2 → 4