Wheel Nut Torque for Renault Trafic Trafic III (X82) (2014–present)
2014–present · Australian Market
The wheel nut torque for the Renault Trafic Trafic III (X82) (2014–present) is 175 Nm (≈ 130 ft·lbs), tightened in a star pattern with a calibrated torque wrench.
Wheel Nut Torque
≈ 130 ft·lbs
Socket Size
19mm
Bolt Pattern
5x114.3
Thread Size
M14 x 1.5
Source
Renault Trafic III owner manual — 175 Nm
Always verify with your vehicle's owner manual. Use a calibrated torque wrench. TorqSpec accepts no liability for damage or injury.
Frequently Asked Questions
What is the wheel nut torque for the Renault Trafic Trafic III (X82) (2014–present)?
The wheel nut torque for the Renault Trafic Trafic III (X82) is 175 Nm (≈ 130 ft·lbs), shown in the torque specification card at the top of this page. Use a calibrated torque wrench set to this value, following the star-pattern tightening sequence shown in the diagram further down this page.
What socket size do I need for Renault Trafic wheel nuts?
You'll need a 19mm socket, shown in the Socket Size card in the hardware specifications section of this page. The matching M14 x 1.5 thread and 5x114.3 stud pattern are displayed alongside it in the same grid.
What is the bolt pattern for the Renault Trafic Trafic III (X82)?
The Renault Trafic Trafic III (X82) uses a 5x114.3 bolt pattern (5 studs), shown in the Bolt Pattern card in the hardware specifications section of this page. The thread size is M14 x 1.5.
What is the correct wheel nut tightening sequence for the Renault Trafic?
Tighten the wheel nuts in a star (cross) pattern — never sequentially around the wheel — so clamping force spreads evenly across the 5 studs. The exact tightening sequence for the 5-stud Renault Trafic wheel is shown in the diagram on this page. Torque in stages (snug, then half torque, then full torque) and re-check after 50–100 km.
5-Stud Wheel
Correct Tightening Pattern
Sequence: 1 → 3 → 5 → 2 → 4