Wheel Nut Torque for Renault Master Master II (JD) (1998–2010)
1998–2010 · Australian Market
The wheel nut torque for the Renault Master Master II (JD) (1998–2010) is 160 Nm (≈ 118 ft·lbs), tightened in a star pattern with a calibrated torque wrench.
Wheel Nut Torque
≈ 118 ft·lbs
Socket Size
19mm
Bolt Pattern
5x130
Thread Size
M14 x 1.5
Source
Renault Master II owner manual — 160 Nm
Always verify with your vehicle's owner manual. Use a calibrated torque wrench. TorqSpec accepts no liability for damage or injury.
Frequently Asked Questions
What is the wheel nut torque for the Renault Master Master II (JD) (1998–2010)?
The wheel nut torque for the Renault Master Master II (JD) is 160 Nm (≈ 118 ft·lbs), shown in the torque specification card at the top of this page. Use a calibrated torque wrench set to this value, following the star-pattern tightening sequence shown in the diagram further down this page.
What socket size do I need for Renault Master wheel nuts?
You'll need a 19mm socket, shown in the Socket Size card in the hardware specifications section of this page. The matching M14 x 1.5 thread and 5x130 stud pattern are displayed alongside it in the same grid.
What is the bolt pattern for the Renault Master Master II (JD)?
The Renault Master Master II (JD) uses a 5x130 bolt pattern (5 studs), shown in the Bolt Pattern card in the hardware specifications section of this page. The thread size is M14 x 1.5.
What is the correct wheel nut tightening sequence for the Renault Master?
Tighten the wheel nuts in a star (cross) pattern — never sequentially around the wheel — so clamping force spreads evenly across the 5 studs. The exact tightening sequence for the 5-stud Renault Master wheel is shown in the diagram on this page. Torque in stages (snug, then half torque, then full torque) and re-check after 50–100 km.
5-Stud Wheel
Correct Tightening Pattern
Sequence: 1 → 3 → 5 → 2 → 4