Wheel Nut Torque for Renault Kangoo Kangoo II (KW) (2007–2021)
2007–2021 · Australian Market
The wheel nut torque for the Renault Kangoo Kangoo II (KW) (2007–2021) is 100 Nm (≈ 74 ft·lbs), tightened in a star pattern with a calibrated torque wrench.
Wheel Nut Torque
≈ 74 ft·lbs
Socket Size
17mm
Bolt Pattern
5x108
Thread Size
M12 x 1.5
Source
Renault Kangoo II owner manual — 100 Nm
Always verify with your vehicle's owner manual. Use a calibrated torque wrench. TorqSpec accepts no liability for damage or injury.
Frequently Asked Questions
What is the wheel nut torque for the Renault Kangoo Kangoo II (KW) (2007–2021)?
The wheel nut torque for the Renault Kangoo Kangoo II (KW) is 100 Nm (≈ 74 ft·lbs), shown in the torque specification card at the top of this page. Use a calibrated torque wrench set to this value, following the star-pattern tightening sequence shown in the diagram further down this page.
What socket size do I need for Renault Kangoo wheel nuts?
You'll need a 17mm socket, shown in the Socket Size card in the hardware specifications section of this page. The matching M12 x 1.5 thread and 5x108 stud pattern are displayed alongside it in the same grid.
What is the bolt pattern for the Renault Kangoo Kangoo II (KW)?
The Renault Kangoo Kangoo II (KW) uses a 5x108 bolt pattern (5 studs), shown in the Bolt Pattern card in the hardware specifications section of this page. The thread size is M12 x 1.5.
What is the correct wheel nut tightening sequence for the Renault Kangoo?
Tighten the wheel nuts in a star (cross) pattern — never sequentially around the wheel — so clamping force spreads evenly across the 5 studs. The exact tightening sequence for the 5-stud Renault Kangoo wheel is shown in the diagram on this page. Torque in stages (snug, then half torque, then full torque) and re-check after 50–100 km.
5-Stud Wheel
Correct Tightening Pattern
Sequence: 1 → 3 → 5 → 2 → 4