Wheel Nut Torque for Mazda 323 FA (RWD) (1977–1981)
1977–1981 · Australian Market
The wheel nut torque for the Mazda 323 FA (RWD) (1977–1981) is 88–110 Nm, tightened in a star pattern with a calibrated torque wrench.
Wheel Nut Torque
OEM Range
Socket Size
21mm
Bolt Pattern
4x110
Thread Size
M12 x 1.5
Source
NJY professional OE torque chart (p.29) — 323 to 1982: 88–110 Nm (65–80 ft-lbs)
Always verify with your vehicle's owner manual. Use a calibrated torque wrench. TorqSpec accepts no liability for damage or injury.
Frequently Asked Questions
What is the wheel nut torque for the Mazda 323 FA (RWD) (1977–1981)?
The wheel nut torque for the Mazda 323 FA (RWD) is 88–110 Nm, shown in the torque specification card at the top of this page. Use a calibrated torque wrench set anywhere within this OEM range, following the star-pattern tightening sequence shown in the diagram further down this page.
What socket size do I need for Mazda 323 wheel nuts?
You'll need a 21mm socket, shown in the Socket Size card in the hardware specifications section of this page. The matching M12 x 1.5 thread and 4x110 stud pattern are displayed alongside it in the same grid.
What is the bolt pattern for the Mazda 323 FA (RWD)?
The Mazda 323 FA (RWD) uses a 4x110 bolt pattern (4 studs), shown in the Bolt Pattern card in the hardware specifications section of this page. The thread size is M12 x 1.5.
What is the correct wheel nut tightening sequence for the Mazda 323?
Tighten the wheel nuts in a star (cross) pattern — never sequentially around the wheel — so clamping force spreads evenly across the 4 studs. The exact tightening sequence for the 4-stud Mazda 323 wheel is shown in the diagram on this page. Torque in stages (snug, then half torque, then full torque) and re-check after 50–100 km.
4-Stud Wheel
Correct Tightening Pattern
Sequence: 1 → 3 → 2 → 4