Wheel Nut Torque for Jeep Wrangler JK (2007–2018)
2007–2018 · Australian Market
The wheel nut torque for the Jeep Wrangler JK (2007–2018) is 130 Nm (≈ 95 ft·lbs), tightened in a star pattern with a calibrated torque wrench.
Wheel Nut Torque
≈ 95 ft·lbs
Socket Size
21mm
Bolt Pattern
5x127mm (5")
Thread Size
1/2-20
Source
NJY professional OE torque chart (p.26) — Wrangler 2008-17: 130 Nm (95 ft-lbs). Corrected from 115-169 range 2026-07
Always verify with your vehicle's owner manual. Use a calibrated torque wrench. TorqSpec accepts no liability for damage or injury.
Frequently Asked Questions
What is the wheel nut torque for the Jeep Wrangler JK (2007–2018)?
The wheel nut torque for the Jeep Wrangler JK is 130 Nm (≈ 95 ft·lbs), shown in the torque specification card at the top of this page. Use a calibrated torque wrench set to this value, following the star-pattern tightening sequence shown in the diagram further down this page.
What socket size do I need for Jeep Wrangler wheel nuts?
You'll need a 21mm socket, shown in the Socket Size card in the hardware specifications section of this page. The matching 1/2-20 thread and 5x127mm (5") stud pattern are displayed alongside it in the same grid.
What is the bolt pattern for the Jeep Wrangler JK?
The Jeep Wrangler JK uses a 5x127mm (5") bolt pattern (5 studs), shown in the Bolt Pattern card in the hardware specifications section of this page. The thread size is 1/2-20.
What is the correct wheel nut tightening sequence for the Jeep Wrangler?
Tighten the wheel nuts in a star (cross) pattern — never sequentially around the wheel — so clamping force spreads evenly across the 5 studs. The exact tightening sequence for the 5-stud Jeep Wrangler wheel is shown in the diagram on this page. Torque in stages (snug, then half torque, then full torque) and re-check after 50–100 km.
5-Stud Wheel
Correct Tightening Pattern
Sequence: 1 → 3 → 5 → 2 → 4