Wheel Nut Torque for Hyundai IONIQ 5 NE1 (2021–present)
2021–present · Australian Market
The wheel nut torque for the Hyundai IONIQ 5 NE1 (2021–present) is 107–127 Nm, tightened in a star pattern with a calibrated torque wrench.
Wheel Nut Torque
OEM Range
Socket Size
21mm
Bolt Pattern
5x114.3
Thread Size
M12 x 1.5
Source
Hyundai IONIQ 5 NE1 owner manual — 107–127 Nm OEM range (79–94 lb-ft); confirmed Ioniq5 N forum official manual citation
Always verify with your vehicle's owner manual. Use a calibrated torque wrench. TorqSpec accepts no liability for damage or injury.
Frequently Asked Questions
What is the wheel nut torque for the Hyundai IONIQ 5 NE1 (2021–present)?
The wheel nut torque for the Hyundai IONIQ 5 NE1 is 107–127 Nm, shown in the torque specification card at the top of this page. Use a calibrated torque wrench set anywhere within this OEM range, following the star-pattern tightening sequence shown in the diagram further down this page.
What socket size do I need for Hyundai IONIQ 5 wheel nuts?
You'll need a 21mm socket, shown in the Socket Size card in the hardware specifications section of this page. The matching M12 x 1.5 thread and 5x114.3 stud pattern are displayed alongside it in the same grid.
What is the bolt pattern for the Hyundai IONIQ 5 NE1?
The Hyundai IONIQ 5 NE1 uses a 5x114.3 bolt pattern (5 studs), shown in the Bolt Pattern card in the hardware specifications section of this page. The thread size is M12 x 1.5.
What is the correct wheel nut tightening sequence for the Hyundai IONIQ 5?
Tighten the wheel nuts in a star (cross) pattern — never sequentially around the wheel — so clamping force spreads evenly across the 5 studs. The exact tightening sequence for the 5-stud Hyundai IONIQ 5 wheel is shown in the diagram on this page. Torque in stages (snug, then half torque, then full torque) and re-check after 50–100 km.
5-Stud Wheel
Correct Tightening Pattern
Sequence: 1 → 3 → 5 → 2 → 4