Wheel Nut Torque for Ford Falcon XM (1964–1965)
1964–1965 · Australian Market
The wheel nut torque for the Ford Falcon XM (1964–1965) is 70–90 Nm, tightened in a star pattern with a calibrated torque wrench.
Wheel Nut Torque
OEM Range
Socket Size
13/16
Bolt Pattern
5x114.3
Thread Size
7/16 UNF
Source
NJY professional OE torque chart — Falcon XM 70–90 Nm (50–65 ft-lbs)
Always verify with your vehicle's owner manual. Use a calibrated torque wrench. TorqSpec accepts no liability for damage or injury.
Frequently Asked Questions
What is the wheel nut torque for the Ford Falcon XM (1964–1965)?
The wheel nut torque for the Ford Falcon XM is 70–90 Nm, shown in the torque specification card at the top of this page. Use a calibrated torque wrench set anywhere within this OEM range, following the star-pattern tightening sequence shown in the diagram further down this page.
What socket size do I need for Ford Falcon wheel nuts?
You'll need a 13/16 socket, shown in the Socket Size card in the hardware specifications section of this page. The matching 7/16 UNF thread and 5x114.3 stud pattern are displayed alongside it in the same grid.
What is the bolt pattern for the Ford Falcon XM?
The Ford Falcon XM uses a 5x114.3 bolt pattern (5 studs), shown in the Bolt Pattern card in the hardware specifications section of this page. The thread size is 7/16 UNF.
What is the correct wheel nut tightening sequence for the Ford Falcon?
Tighten the wheel nuts in a star (cross) pattern — never sequentially around the wheel — so clamping force spreads evenly across the 5 studs. The exact tightening sequence for the 5-stud Ford Falcon wheel is shown in the diagram on this page. Torque in stages (snug, then half torque, then full torque) and re-check after 50–100 km.
5-Stud Wheel
Correct Tightening Pattern
Sequence: 1 → 3 → 5 → 2 → 4