Wheel Nut Torque for Ford Everest Next-Gen (P703-based) (2022–present)
2022–present · Australian Market
The wheel nut torque for the Ford Everest Next-Gen (P703-based) (2022–present) is 135 Nm (≈ 100 ft·lbs), tightened in a star pattern with a calibrated torque wrench.
Wheel Nut Torque
≈ 100 ft·lbs
Socket Size
21mm
Bolt Pattern
6x139.7
Thread Size
M14 x 1.5
Source
Ford Everest Owner's Manual (fordservicecontent.com) — 135 Nm (100 lb·ft). Corrected from 150 Nm 2026-08
Always verify with your vehicle's owner manual. Use a calibrated torque wrench. TorqSpec accepts no liability for damage or injury.
Frequently Asked Questions
What is the wheel nut torque for the Ford Everest Next-Gen (P703-based) (2022–present)?
The wheel nut torque for the Ford Everest Next-Gen (P703-based) is 135 Nm (≈ 100 ft·lbs), shown in the torque specification card at the top of this page. Use a calibrated torque wrench set to this value, following the star-pattern tightening sequence shown in the diagram further down this page.
What socket size do I need for Ford Everest wheel nuts?
You'll need a 21mm socket, shown in the Socket Size card in the hardware specifications section of this page. The matching M14 x 1.5 thread and 6x139.7 stud pattern are displayed alongside it in the same grid.
What is the bolt pattern for the Ford Everest Next-Gen (P703-based)?
The Ford Everest Next-Gen (P703-based) uses a 6x139.7 bolt pattern (6 studs), shown in the Bolt Pattern card in the hardware specifications section of this page. The thread size is M14 x 1.5.
What is the correct wheel nut tightening sequence for the Ford Everest?
Tighten the wheel nuts in a star (cross) pattern — never sequentially around the wheel — so clamping force spreads evenly across the 6 studs. The exact tightening sequence for the 6-stud Ford Everest wheel is shown in the diagram on this page. Torque in stages (snug, then half torque, then full torque) and re-check after 50–100 km.
6-Stud Wheel
Correct Tightening Pattern
Sequence: 1 → 4 → 2 → 5 → 3 → 6